NA-1 adopts uniquely asymmetric pattern design. The inside pattern stresses on drainage performance. Larger void ratio improves drainage performance on wet roads. The enlarged third section of tread radius lessen contact pressure of tread shoulder, and further reduce the noise generated from the lateral grooves on tread shoulder.
Light-weight profile and narrow tread width design reduce rolling resistance. The outside pattern emphasizes on manoeuvrability. The larger pattern blocks on tread shoulder offers better cornering handling. Noise prevention bar on the lateral grooves of outside tread shoulder block airflow in the grooves to reduce the derived noise. Chamfered groove wall design scarifies the water film for getting a better wet grip.
EU Tyre Label and Efficiency Classes
The European Union has introduced the EU Tyre Label by Regulation (No. 1222/2009) identically and bindingly for all EU member states. It applies to passenger car tyres, light commercial vehicle tyres and heavy commercial vehicle tyres produced after 01.07.2012.
Three different areas are tested: rolling resistance, wet grip and the rolling noise the tyre makes on the road.
The following are not affected by the EU Tyre Label: retreaded tyres, professional off-road tyres, racing tyres, tyres with additional devices to improve traction such as spiked tyres, T-type emergency tyres, special tyres for fitting to vehicles first registered before 1 October 1990, tyres with a maximum authorised speed of 80 km/h, tyres for rims with a nominal diameter of 254 mm or less or 635 mm or more.
With this regulation, the European Union is pursuing the goal of promoting economic and ecological efficiency in road traffic as well as increasing road safety on the one hand, and on the other hand, granting consumers more product transparency and at the same time serving as an active decision-making aid.
Already during the incorporation, experts criticise the fact that the EU Tyre Label unfortunately only shows a few product characteristics. Apart from rolling resistance, wet grip and rolling noise, which are the main focus of EU tyre labelling, tyres have much more important and safety-relevant product characteristics, such as aquaplaning properties, driving stability, service life, braking properties on dry and wet roads, behaviour in wintry conditions, etc.
Tyre manufacturers point out that test results from various institutions and journals remain an important information medium for the end consumer. These tests usually focus on further safety-relevant product characteristics besides the EU standard qualifications for tyre labelling, which are always important for the final customer.
Econex NA-1 tyre review
Average based on 641 test results
Grip in dry conditions
Braking in dry conditions
Grip in wet conditions
Braking in wet conditions
Grip in snow N/A
Internal noise level
Kilometers driven 8,834
04.01.2022fromcolin I have tried virtually every chinese built tyre over the years on my classic mini and they dont last more than 5000 miles. The rubber compound is too soft, I get through at least one set of tyres a year. They were cheap but are now getting more expensive. Tyres from mytyres are shipped from germany, not oxford, and mine took 6 weeks to arrive...
16.04.2021fromKate One tire blow after only 2-3 months
05.10.2020fromSean Cunningham The car feels nice on these tyres.
28.10.2019fromelemer pinter It's good to drive with this tire. I feel safe.
Managing cookie setting
These cookies are necessary for navigating pages and using basic functions
Analytical cookies, marketing cookies, services of other companies (independent third-party providers)
These cookies help us better understand user behavior.
These cookies and similar technologies are used to display personalized and therefore relevant advertising content.